Ignition Lock Cylinder

Ignition Lock Cylinder Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.





2. Remove the lock cylinder bezel from the steering column shroud by carefully prying with a thin-bladed screwdriver.





3. Remove the steering column upper trim panel.
4. Remove wiper/washer switch.





5. Insert the key into the lock cylinder and rotate to START position.

Important: While rotating the cylinder back to the START position, depress the locking button on the top of the ignition module with a thin pick-type tool.

6. Slide the lock cylinder from ignition lock cylinder case.

Installation Procedure






Important: The actuator blade within the ignition module housing must be in the RUN position to install the lock cylinder assembly. If rotated, replace it to the RUN position using needle nose pliers.

1. Insert the key into the ignition lock cylinder and install it into the ignition lock cylinder case.
2. Install the wiper/washer switch.





3. Install the steering column upper trim cover.
4. Reconnect the negative battery cable.