86. Drive, Driven Sprockets and Drive Link Assemble
Drive, Driven Sprockets and Drive Link AssembleTools Required
^ J29569-1 Turbine Shaft Seal Installer
^ J29569-2 Turbine Shaft Seal Sizer
1. Assemble the drive sprocket (37) onto the turbine shaft (39).
2. Retain the drive sprocket with the turbine shaft to drive sprocket snap ring (35).
3. In order to assemble three new Teflon seals (33, 40) onto the turbine shaft (39), perform the following procedure:
3.1. Slide both halves of the J29569-1 over the turbine shaft.
3.2. Coat the J29569-1 with transmission fluid.
3.3. Use your fingers in order to guide the new Teflon seals over the J29569-1 and into the seal ring grooves on the turbine shaft.
3.4. Remove the J29569-1 when the seals are in place.
3.5. Size the new Teflon(tm) seals. Use both halves of the J29569-2.
3.6. In order to properly size the seals. keep the J29569-2 in place for five minutes.