31. Piston and Connecting Rod Assemble

Piston and Connecting Rod Assemble

^ Tools Required
- SA9101E Piston Pin Remover/Installer





1. Perform the following steps to assemble the piston assembly to the connecting rod.
2. Install the oil ring expander and the 2 side rails by hand.

Important: The arrow on the top of the piston must point toward the front of the engine.
^ Align the number 1 compression ring gap at 6 o'clock (1).
^ Align number 2 compression ring gap at 12 o'clock (2).
^ Align the upper oil control side rail gap at 1 o'clock (3).
^ Align the oil ring spacer expander at 9 o'clock (4).
^ Align the lower oil control side rail gap at 5 o'clock (5).






Important: The bumps on the connecting rod must face toward the flex plate.

3. Assemble the piston to the connecting rod.






Important: The arrow on the piston points toward the front of the engine and the bump on the connecting rod faces toward the rear of the engine.

4. Use the SA9101E to assemble the piston pin to the connecting rod and the piston, if necessary.





5. Install the piston pin clips in the piston.