55. Camshaft Drive Sprocket Installation

Camshaft Drive Sprocket Installation

^ Tools Required
- J 42069 Timing Belt Alignment Kit

Important: Install the alignment pin in the correct numbered, alignment slot on the camshaft gear.





1. Install the camshaft gear.






Notice: Refer to Fastener Notice in Service precautions.

Important: Use a new camshaft gear bolt. The required tightening method will stretch to its yield point, therefore, the bolt is not reusable.

2. Install the camshaft gear bolt.
^ Use the kits tools J 42069-1 and J 42069-2 within the J 42069 to hold the camshaft gear and the camshaft in place while tightening the camshaft gear bolt.
^ Tighten the camshaft gear bolt.
^ Tighten the camshaft gear bolt to 50 Nm (37 ft. lbs.), plus 60° plus 15°.