Multifunction Turn Signal Switch Housing Replacement
Multifunction Turn Signal Switch Housing ReplacementRemoval Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the steering wheel.
3. Remove the SIR coil.
4. Remove the upper and lower shrouds.
5. Depress the lock tabs on the left and right multi-function levers. Remove the multi-function levers.
6. Disconnect the housing electrical connectors.
7. Remove the housing form the steering column.
Installation Procedure
1. Slide the bracket onto the column.
2. Hand tighten the lower bolt until snug.
3. Hand tighten the upper bolt until snug.
Notice: Refer to Fastener Notice in Service Precautions.
4. Tighten the lower bolt.
Tighten the bolt to 8 Nm (71 inch lbs.).
5. Tighten the upper bolt.
Tighten the bolt to 8 Nm (71 inch lbs.).
6. Connect the ignition housing electrical connectors.
Important: Ensure that both locking tabs are seated.
7. Install the multi-function levers.
8. Install the upper and lower shrouds.
Tighten the shroud screws to 4 Nm (35 inch lbs.).
9. Install the SIR coil.
10. Install the steering wheel.
11. Connect the negative battery cable.