Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
3. Remove the MAP sensor attachment bolt and remove the MAP sensor with the grommet.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Make sure the MAP sensor mounting surface is clean. Install the MAP sensor with the grommet and attachment bolt.
Tighten the manifold absolute pressure sensor bolt to 5 N.m (44 lb in).
2. Connect the MAP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.