Shift Interlock Control Module: Service and Repair

Shift Lock Control Module Replacement

Removal Procedure
1. Disable the SIR System.
2. Remove the console.





3. Using a screwdriver, disconnect the control cable end from the pin on the control assembly.
4. Remove the control cable retaining clip.
5. Press the tabs on the control cable and remove the cable from the control assembly.





6. Disconnect the control assembly electrical connectors.





7. Remove the control assembly-to-floor pan bolts and remove the control assembly.
8. If the shifter control assembly is being replaced, transfer the parts as needed.

Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the control assembly into the vehicle and install the control assembly-to-floor pan bolts.
Tighten the control assembly-to-floor pan bolts to 8 Nm (71 inch lbs.).





2. Connect the control assembly electrical connectors.





3. Connect the control cable to the pin on the control assembly.
4. Secure the control cable into the control assembly by pushing into place.
5. Install the control cable retaining clip.
6. Install the console.
7. Enable the SIR system.