Powertrain Control Module (PCM) - Programming and Setup

POWERTRAIN CONTROL MODULE PROGRAMMING AND SETUP

The following service procedures require either a programming or a setup event be performed for a complete repair.

Powertrain Control Module (PCM) Replacement
If the powertrain control module (PCM) is replaced, the following procedures must be performed:
1. PCM Reprogramming - Refer to Service Programming System (SPS).
2. Crankshaft Position (CKP) Variation Learn-Refer to CKP System Variation Learn Procedure in Computers and Control Systems - 2.2L (L61)

PCM Reprogramming
If the PCM needs to be reprogrammed, refer to Service Programming System (SPS).

Setup For Component Replacement
The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, a crankshaft position (CKP) variation learn procedure must be performed.
- Engine replacement
- Any engine repair that disturbs the crankshaft position CKP sensor or its relationship with the crankshaft reluctor wheel
- CKP sensor