Extension Replacement - Floor Console - Center

Extension Replacement - Floor Console - Center

Removal Procedure

1. If equipped with an automatic or VTi transmission, apply the park brake and shift the transmission into neutral.




2. If equipped with an automatic or VTi transmission, remove the console shift lever bezel by carefully lifting up around the outside edge.




3. If equipped with a manual transmission, unsnap the shift boot from the front console cupholder.




4. Lift the front console cupholder to disengage the retaining fasteners.
5. Disconnect the cigar lighter electrical connector.




6. Remove the front console cupholder. If equipped with a manual transmission, slide the shift boot through the front console cupholder.




7. Remove the left console side extension retainer. Turn the retainer counterclockwise to remove.
8. Remove the right console side extension retainer. Turn the retainer counterclockwise to remove.




9. Remove the left console side extension by pulling the console side extension rearward to disengage from the console.
10. Remove the right console side extension by pulling the console side extension rearward to disengage from the console.




11. Remove the console center extension screws.
12. Pull out on the console center extension to disengage the retaining fasteners and remove the extension.



Installation Procedure





1. Align the retaining fasteners on the console center extension with the instrument panel (I/P) retainer. Push the extension to secure.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the console center extension screws.

Tighten the console center extension screws to 2.5 N.m (22 lb in).





3. If equipped with a manual transmission, slide the shift boot through the front console cupholder.
4. Connect the cigar lighter electrical connector.




5. Align the retaining fasteners on the front console cupholder with the console.
6. Push the front console cupholder to secure.




7. If equipped with a manual transmission, snap the shift boot to the front console cupholder.




8. If equipped with an automatic or VTi transmission, align the fingers on the shift lever bezel with the slots on the shift lever base. Push the console shift lever bezel to secure.
9. If equipped with an automatic or VTi transmission, shift the transmission into Park.




10. Install the console side extensions.
11. Align the clips on the console side extensions with the slots in the console.
12. Slide the console side extensions forward to engage the clips with the console.




13. Install the console side extension retainers and turn clockwise to secure.