Instrument Panel (IP) - Center Support Bracket Replacement

Bracket Replacement - Instrument Panel (I/P) Center Support

Removal Procedure

1. Remove the front floor console. Refer to Console Replacement - Front Floor (Console Replacement - Front Floor) .




2. Remove the wiring harness rosebud from the center support bracket.




3. Pull back the carpet at the bottom of the center support bracket and remove the center support bracket lower nuts.
4. Remove the center support bracket nuts and remove the bracket.



Installation Procedure





1. Pull back the carpet and position the center support bracket into position.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the center support bracket nuts.

Tighten the center support bracket nuts to 10 N.m (88 lb in).





3. Install the wiring harness rosebud to the center support bracket.
4. Install the fron floor console. Refer to Console Replacement - Front Floor (Console Replacement - Front Floor) .