Instrument Panel Cluster (IPC) - Trim Plate Bezel Replacement

Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster

Removal Procedure





1. Pull out on the accessory trim plate in order to release the retaining fasteners.




2. Disconnect the accessory trim plate electrical connector(s).




3. Remove the screw retaining the cluster trim plate to the center trim panel.
4. Lift up on the cluster trim plate to release the retaining fasteners.
5. Remove the cluster trim plate.



Installation Procedure





1. Align the retaining fasteners with the center trim panel.
2. Push on the outer edge of the cluster trim plate in order to secure the retaining fasteners.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the screw retaining the cluster trim plate to the center trim panel.

Tighten the cluster trim plate screw to 2.5 N.m (22 lb in).





4. Connect the accessory trim plate electrical connector(s).




5. Align the retaining fasteners with the I/P.
6. Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.