66. Engine Prelubing

Engine Prelubing

Tools Required
J 45299 Engine Preluber





1. Locate the oil pressure switch and remove.

Important: A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.

2. Install the M12 x 1.75 adapter P/N 509376.





3. Install the flexible hose to the adapter and open the valve.
4. Pump the handle on the J 45299 in order to flow a minimum of 11.9 liters (12 quarts) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
5. Close the valve and remove the flexible hose and adapter from the engine.
6. Install the oil pressure switch to the engine.

Notice: Refer to Fastener Notice in Cautions and Notices.

^ Tighten the oil pressure switch to 22 N.m (16 lb ft).

7. Topoff the engine oil to the proper level.