Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor Replacement

Removal Procedure




1. Remove the intake manifold cover. if required.
2. Remove the power steering pump, if required.
3. Disconnect the fuel injector wiring harness electrical connector from the camshaft position (CMP) sensor.




4. Remove the CMP sensor bolt.
5. Remove the CMP sensor.
6. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.

Installation Procedure




1. Replace the O-ring seal if damaged, lubricate the NEW O-ring with clean engine oil.
2. Install the CMP sensor.

Notice: Refer to Fastener Notice.

3. Install the CMP sensor bolt.

Tighten the bolt to 10 N.m (89 lb in).




4. Connect the fuel injector wiring harness electrical connector to the CMP sensor.
5. Install the power steering pump, if required.
6. Install the intake manifold cover. if required.