Body Control Module: Service and Repair

Body Control Module Replacement

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove the right console trim panel.
3. Remove the body control module (BCM) screws.
4. Remove the BCM wire harness connectors.




5. Remove the BCM.

Installation Procedure




1. Install the BCM.
2. Install the BCM wire harness connectors.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the BCM screws.

Tighten the screws to 2.5 Nm (22 lb in).

4. Install the right console trim panel.
5. Connect the negative battery cable.
6. For a new or remanufactured BCM, program the BCM. Refer to Body Control Module Programming and Setup. Programming and Relearning