Lighting - Fog Lamp Bezel Distorted After Washing Car
Bulletin No.: 07-08-42-004Date: March 13, 2007
TECHNICAL
Subject:
Fog Lamp Bezel Surface Distorted (Install New Designed Bezel)
Models:
2007 Saturn AURA XR
Condition
Some customers may comment that, after washing their vehicle, the fog lamp bezel surface is distorted.
Cause
This condition may be caused by reflection of the sun in the fog lamp lens.
Correction
Replace the fog lamp bezel. At the time of the repair, replace both sides.
Using a flat bladed tool, release the fog lamp bezel from the fascia. Remove the bezel.
Using a punch, make a mark in the fascia where the two darker liners meet, or come to a point, as shown in the illustration above.
Use duct tape in order to protect the fascia surface from damage.
Using a 1/8 inch drill bit, drill a pilot hole in the fascia.
Using a hole saw, drill a 25 mm (1 in) hole in the fascia. This will provide the necessary clearance for the new design bezel.
Install the new designed fog lamp bezel, making sure all the clips are fully seated.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer