Transmission Mount Replacement - Left Side

TRANSMISSION MOUNT REPLACEMENT - LEFT SIDE (RPO LZ4)

Removal Procedure
1. Raise and support the vehicle.
2. Remove the left front tire and wheel.
3. Remove the left splash shield.
4. Using a suitable floor jack and block of wood, support the powertrain.






5. Remove the transaxle mount lower nuts from the frame.






6. Remove the transmission mount upper nuts from the transmission mount bracket.
7. Use the floor jack to raise the powertrain enough to remove the transmission mount.
8. Remove the transaxle mount from the frame.

Installation Procedure

1. Install the transaxle mount to the frame.






2. Install the transmission mount to frame bolts. Hand tighten only.
3. Use the jackstand to lower the transmission mount bracket on to the transmission mount studs.






4. Install the transmission mount to bracket upper nut. Hand tighten only.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Tighten the transmission mount nut and bolts.

Tighten
- Tighten the transmission mount upper nuts to 50 Nm (37 lb ft).
- Tighten the transmission mount lower bolts to 50 Nm (37 lb ft).

6. Install the left splash shield.
7. Install the left front tire and wheel.
8. Lower the vehicle.