Engine Support Fixture

Engine Support Fixture

Installation Procedure

Tools Required

* J 28467-B Universal Engine Support Fixture
* J 36857 Engine Support Adapter
* J 28467-500 Engine Support Fixture

1. Remove the fuel injector sight shield.
2. Remove the air cleaner assembly.
3. Remove the air cleaner outlet duct.
4. Remove the engine mount bracket.
5. Remove power steering reservoir and place aside.
6. Remove intake cam sensor.
7. Remove the upper intake manifold.




8. Install the engine mount bracket with the engine support bracket J 36857 to the engine.




9. Remove engine harness clip from the holding stud.




10. Remove engine harness clamp, then position harness aside.




11. Install engine support bracket J 36857 to left cylinder head.




12. Install the thread support nuts J-28467-33A onto the strut attaching studs.
13. Install the strut tower support assemblies J-28467-5A over the thread support nuts J-28467-33A.
14. Install the T-bolts J-28467-5 with 5/16 inch washers through the strut tower support assemblies J-28467-5A into the thread support nuts J-28467-33A. Hand tighten the bolts.
15. Install the strut tower tube J-28467-3 into the strut tower support assemblies J-28467-5A.
16. Install the 1/2 inch x 2.5 inch quick release pin J-28467-10 through the strut tower support assemblies J-28467-5A and the strut tower tube J-28467-3 on one side only.




17. Install two front support assembly J-28467-4A and two radiator shelf tube J-28467-2A to the strut tower tube J-28467-3.




18. Install the cross bracket assembly J-24867-1A to secure the radiator shelf tube J-28467-2A to the strut tower tube J-28467-3.




19. Assemble the lift hook wing nut J-28467-34 and the lift hook bracket J-28467-6A to the lift hook J-28467-7A.




20. Install lift hook assembly to the radiator shelf tube (2).




21. Install lift hook assembly to the left side J-42451-1.




22. Assemble the lift hook wing nut J-28467-34 and the lift hook bracket J-28467-6A to the lift hook J-28467-7A.




23. Install lift hook assembly to the radiator shelf tube (2).




24. Install lift hook assembly to right side J-42451-1.
25. Tighten the J 28467-34 wing nut until all free slack is removed from the J 28467-7A lift hook.