Fuel Injector and Fuel Rail Replacement

Fuel Injector and Fuel Rail Replacement

Removal Procedure

Caution: Refer to Gasoline/Gasoline Vapors Caution.




1. Remove the fuel injector sight shield.
2. Disconnect the engine wiring harness electrical connector (1) from the fuel injector wiring harness electrical connector.




3. Disconnect the fuel feed pipe (1) quick connect fitting from the fuel rail.
4. Remove the upper intake manifold.






Caution: Refer to Safety Glasses and Compressed Air Caution.

5. Use compressed air in order to remove any debris from the around the area where the fuel injectors enter the lower intake manifold.
6. Remove the fuel rail bolts.

Notice:
* Remove the fuel rail assembly carefully in order to prevent damage to the injector electrical connector terminals and the injector spray tips. Support the fuel rail after the fuel rail is removed in order to avoid damaging the fuel rail components.

* Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering open pipes and passages.

Remove the fuel rail with fuel injectors from the lower intake manifold.




7. Lift up the fuel injector electrical connector retainer (2).
8. Push in the fuel injector electrical connector tab (1) in order to disconnect the connector from the injector.




9. Remove the fuel injector retainer clip.




10. Remove the fuel injector.
11. Remove and discard the fuel injector seals.

Installation Procedure




1. Install NEW fuel injector seals.
2. Install the fuel injector.




3. Install the fuel injector retainer clip.




4. Install the fuel injector electrical connector.
5. Push down on the fuel injector electrical connector retainer (2), securing the electrical connector.




6. Install the fuel rail with fuel injectors to the lower intake manifold.

Notice: Refer to Fastener Notice.

7. Install the fuel rail bolts.

Tighten the bolts to 10 N.m (89 lb in).




8. Install the upper intake manifold.
9. Connect the fuel feed pipe (1) quick connect fitting to the fuel rail.




10. Connect the engine wiring harness electrical connector (1) to the fuel injector wiring harness electrical connector.
11. Install the fuel injector sight shield.