Ambient Light Sensor: Service and Repair

Ambient Light Sensor Replacement

Removal Procedure




1. Remove the left and right outer trim covers.




2. Pull out on the accessory trim plate in order to release the retaining fasteners.




3. Disconnect the accessory trim plate electrical connectors.




4. Remove the screw retaining the cluster trim plate to the center trim panel.
5. Lift up on the cluster trim plate to release the retaining fasteners.
6. Remove the cluster trim plate.
7. Remove the left and right windshield garnish moldings.




8. Remove the defroster grille bolt covers.




9. Remove the defroster grille center bolts and the outer screws.
10. Lift up on the defroster grille to release the retaining fasteners.




11. Turn the ambient light sensor body clockwise to remove it from the defroster grille.
12. Disconnect the ambient light sensor electrical connector.

Installation Procedure




1. Connect the ambient light sensor electrical connector.
2. Install the ambient light sensor to the defroster grille. Turn the ambient light sensor body counterclockwise to lock it into the defroster grille.




3. Align the defroster grille retaining fasteners with the I/P.
4. Push on the defroster grille in order to secure the retaining fasteners.

Notice: Refer to Fastener Notice.

5. Install the defroster grille center bolts.

Tighten the defroster grille center bolts to 10 N.m (88 lb in).

6. Install the defroster grille outer screws.

Tighten the defroster grille outer screws to 2.5 N.m (22 lb in).




7. Install the defroster grille bolt covers.
8. Install the left and right windshield garnish moldings.




9. Align the cluster trim plate retaining fasteners with the center trim panel.
10. Push on the outer edge of the cluster trim plate in order to secure the retaining fasteners.
11. Install the screw retaining the cluster trim plate to the center trim panel.

Tighten the cluster trim plate screw to 2.5 N.m (22 lb in).




12. Connect the accessory trim plate electrical connectors.




13. Align the retaining fasteners with the I/P.
14. Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.




15. Install the left and right outer trim covers.