Rear Door Jamb Switch Replacement

Rear Door Jamb Switch Replacement

Removal Procedure

1. Open the rear door.




2. Remove the lower garnish molding from the center pillar.
3. Reach into the opening in the center pillar and pinch the tabs together on the door jamb switch (2). Remove the switch from the center pillar.
4. Disconnect the electrical connector (1) from the door jamb switch.

Installation Procedure




1. Connect the electrical connector (1) to the door jamb switch.
2. Press inward on the door jamb switch (2) until fully seated in the hinge pillar.
3. Install the lower garnish molding to the center
4. Close the rear door.