Rear Side Door Window Switch Replacement

Rear Side Door Window Switch Replacement

Removal Procedure

1. Lift the pull cup liner.




2. Remove the pull cup screws from the door trim.
3. Using a small flat-bladed tool, pry the rearward end of the pull cup out of the door trim.
4. Pull rearward to disengage the forward pull cup hook from the door trim.




5. Disconnect the power window switch electrical connector.
6. Disengage the locking tabs that hold the power window switch in the pull cup.
7. Remove the switch from the pull cup.

Installation Procedure




1. Insert the power window switch into the pull cup until the locking tabs engage.
2. Connect the power window switch electrical connector.




3. Insert the forward end of the pull cup into the door trim and push forward to engage the hook.
4. Press down on the rearward end of the pull cup.






Notice: Refer to Fastener Notice in Service Precautions.

5. Install the pull cup screws.

Tighten the screws to 2.5 N.m (23 lb in).

6. Reposition the pull cup liner.