Front Seat Cushion Frame Replacement (Non-Fold Flat)

Front Seat Cushion Frame Replacement (Non-Fold Flat)

Removal Procedure




1. Remove the front seat from the vehicle.
2. Remove the seat side trim.




3. Remove the seat adjuster handle by squeezing the bars toward the center of the seat.
4. On vehicles equipped with 4-way adjusters, raise the driver side seat cushion.




5. Remove the attaching bolts from the seat cushion frame.




6. Disconnect the J hook retainers from the seat cushion cover.
7. Remove the seat cushion cover and pad assembly from the seat cushion frame.

Installation Procedure




1. Install the seat cushion cover and pad assembly onto the seat cushion frame.
2. Connect the J hook retainers.






Notice: Refer to Fastener Notice.

3. Install the attaching bolts to the seat cushion frame.

Tighten the bolts to 12 N.m (106 lb in).




4. Install the seat adjuster handle.
5. Install the seat side trim.




6. Install the front seat to the vehicle.

Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.

7. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup.