Wiper Switch: Service and Repair

Wipers/Washer Switch Replacement

Removal Procedure

1. Remove the steering column trim covers.
2. Disconnect the wipers/washer switch harness connector.




3. Remove the wipers/washer signal switch retaining screws.
4. Remove the wipers/washer signal switch from the steering column.

Installation Procedure






Notice: Refer to Fastener Notice in Service Precautions.

1. Install the wipers/washer signal switch to the steering column.

Tighten the wipers/washer signal switch screws to 2 N.m (17 lb in).

2. Connect the wipers/washer switch harness connector.
3. Install the steering column trim covers.