Operation CHARM: Car repair manuals for everyone.

B1000



DTC B1000

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors
DTC B1000 00
- Engine Control Unit Performance - No Additional Information

DTC B1000 31
- Engine Control Unit Performance - General Checksum Error

DTC B1000 57
- Engine Control Unit Performance - Expected Reaction After Event Did Not Occur

Circuit/System Description

The control module runs a program to detect an internal fault when power up is commanded.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

The control module has detected an internal malfunction.

Action Taken When the DTC Sets

The control module refuses all additional inputs.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.
* A history DTC clears in all of the modules except the sensing and diagnostic module (SDM), when the ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.
* If the code is set in the SDM it will never clear and the Air Bag indicator will remain illuminated.

Circuit/System Verification

Verify that DTC B1000 is not set.

If the DTC is set, perform the setup procedure on the control module. If the DTC resets replace the control module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for control module replacement, setup, and programming Programming and Relearning