DTC 3023

DTC 3011 - 3035

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides and overview of each diagnostic category.

DTC Descriptor

DTC 3011

- Internal Electronic Performance 1

Circuit/System Description

The passenger presence system (PPS) module is used to monitor the pressure profile of any occupant that is sitting in the front outboard passenger seat and communicates the profile classification to the sensing and diagnostic module (SDM). The SDM will either enable or suppress the deployment of the instrument panel (I/P) module based on the profile classification of the occupant. If the PPS module detects DTC 3011-3035 within itself, the PPS module will communicate to the SDM through a non GMLAN communications circuit that a PPS fault is present. The SDM will set DTC B0081 indicating a problem within the PPS and will suppress the deployment of the I/P module and turn the AIR BAG indicator ON.

Conditions for Running the DTC

Ignition voltage is between 9-16 volts.

Conditions for Setting the DTC

The PPS has detected an internal fault.

Action Taken When the DTC Sets

* The PPS will set a DTC, and then communicate with the SDM via non GMLAN circuit.
* The SDM will set DTC B0081.
* The SDM disables the I/P module deployment loop.
* The PPS will turn ON the passenger air bag status OFF indicator.
* The SDM commands the AIR BAG indicator ON via serial data communications.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
* A history DTC will clear once 255 malfunction-free ignition cycles have occurred.

Circuit/System Verification

Important: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.

* PPS module

* PPS module wiring harness

Verify that DTC 3011-3035 are not set.

If any of the DTCs set, replace the PPS module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for PPS module replacement, setup, and programming