AF17-4 - Automatic Transmission
DTC P0562 or P0563
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0562
- System Voltage Low
DTC P0563
- System Voltage High
Circuit/System Description
The transmission control module (TCM) within the control solenoid, w/body and TCM, valve assembly continuously monitors the system voltage on the ignition voltage circuit.
Conditions for Running the DTC
Input Speed is 800 RPM or greater.
Conditions for Setting the DTC
P0562
The TCM detects that battery voltage is less than 9.0 volts for 1 second.
P0563
The TCM detects that battery voltage is greater than 18.0 volts for 1 second.
Action Taken When the DTC Sets
* DTC P0562 and P0563 are Type A DTCs.
* The TCM inhibits Adaptive Control.
* The transmission will operate in 4th gear in D range, Reverse in R range.
Conditions for Clearing the DTC
DTC P0562 and P0563 are Type A DTCs.
Diagnostic Aids
A charging system malfunction may cause variances in system voltage and set voltage related DTCs.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Transmission General Information (Transmission General Information)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference
Control Module References (Programming and Relearning)
Circuit/System Verification
1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 9.0-18.0 volts.
• If not within the specified range, refer to Charging System Test (Charging System Test) .
2. Observe the scan tool TCM Battery Voltage parameter. The reading should be between 9.0-18.0 volts.
3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the transmission control module (TCM).
2. Test for less than 1.0 ohm of resistance between ground circuit terminal 40 and ground.
• If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 41 and ground.
• If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, replace the TCM.
4. If all circuits test normal, replace the TCM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for TCM replacement, setup, and programming