Headlamp Replacement (without Dipped Beam)

Headlamp Replacement (without Dipped Beam)

Removal Procedure

Caution: The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.


Caution: The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:

* Never open the high intensity discharge system ballast or the arc tube assembly starter.
* Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.


Caution: Refer to Halogen Bulb Caution (Technician Safety Information) .

1. Remove front bumper fascia. Refer to Front Bumper Fascia Replacement (Front Bumper Fascia Replacement) .




2. Remove the headlamp.

* Remove the 3 screws (1, 2)
* Release the wiring harness plug (3) and disconnect.
* Remove the headlamps.

3. Remove the lights.

* Open the 2 covers.
* Remove the 3 bulbs.
* Remove the indicator light.
* Remove the bulb from the holder.




Installation Procedure

1. Install the lights.

* Install the 3 bulbs.
* Install the indicator light.
* Install the bulb in the holder.
* Close the 2 covers.


Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the headlamp.
Connect the wiring harness plug.

Tighten the 3 bolts to 2.5 N.m (22 lb in).

3. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (Front Bumper Fascia Replacement) .
4. Adjust the headlamp. Refer to Headlamp Aiming (Adjustments) .