Operation CHARM: Car repair manuals for everyone.

Horn Switch: Service and Repair



Steering Wheel Horn Switch Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .
1. Disconnect battery.
2. Remove the airbag. Refer to Inflatable Restraint Steering Wheel Module Replacement (Service and Repair) .




3. Remove the horn control.

* Disconnect the 2 wiring harness plugs (1).
* Remove the 3 bolts (2).
* Remove the horn switch.
* Remove the signal switch board (3).




Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the horn switch.

* Insert the signal switch board.
* Insert the signal switch control.

Tighten the 3 bolts to 2.5 N.m (22 lb in).

* Connect the 2 wiring harness plug.

2. Install the airbag unit. Refer to Inflatable Restraint Steering Wheel Module Replacement (Service and Repair) .

* Connect and lock the wiring harness plug.
* Clamp the airbag unit in place.

3. Connect the battery.
4. Carry out the readiness test.
After ignition ON, the airbag system readiness check light comes on for 4 seconds and then goes out.
5. For programming procedures, refer to Control Module References (Programming and Relearning) .