Rear Electrical Center or Junction Block Replacement (5 - Door)

Rear Electrical Center or Junction Block Replacement (5 - Door)

Removal Procedure

Important: When replacing the control unit, before removing the control unit, carry out a "Reset" with TECH 2. Refer toControl Module References (Programming and Relearning) .



Caution: Refer toBattery Disconnect Caution (Battery Disconnect Caution) .
1. Disconnect the battery.
2. Open the service flap.




3. Disconnect the wiring harness plug for the rear electrical center.
Disconnect the 6 wiring harness plugs (1, 3).
4. Release the rear electrical center.
Remove the nut (arrow).

Important: Only for vehicles with park pilot control unit.



Important: Please pay attention to this when replacing the rear electrical center. The rear electrical center contains the maximum number of relays and fuses. The rear electrical center will contain surplus relays and fuses.


5. Remove the rear electrical center.
Disconnect the park pilot control unit (2).



Installation Procedure


Important: Only for vehicles with park pilot control unit.


1. Insert the rear electrical center.
Install the park pilot control unit.
2. Install the rear electrical center.
Tighten the nut.
3. Connect the wiring harness plug for the rear electrical center.
Connect the 6 wiring harness plugs.
4. Close the service flap.
5. Connect the battery.

Important: When replacing the electrical center, after fitting the control unit, carry out a Program with TECH 2. Refer toControl Module References (Programming and Relearning) .


6. For programming procedures, refer toControl Module References (Programming and Relearning) .