Automatic Transmission Range Selector Lever Replacement
Automatic Transmission Range Selector Lever Replacement
Removal Procedure
1. Remove the front floor console. Refer to Front Floor Console Replacement (Service and Repair) .
2. Remove the range selector cable (2) from the selector lever.
* Remove the retaining clamp (1).
* Disconnect the selector lever cable from the bracket.
3. Remove the range selector lever assembly.
* Disconnect the wiring harness plug (1).
* Remove the 4 bolts (2).
* Remove the selector lever assembly.
Installation Procedure
Notice: Refer to Fastener Notice (Fastener Notice) .
1. Install the selector lever assembly.
* Insert the range selector lever assembly.
Tighten the 4 bolts to 5 N.m (44 lb in).
* Connect the wiring harness plug (1).
2. Install the selector cable (2) to the selector lever.
* Install the selector lever cable to the bracket.
* Install the retaining clamp.
3. Install the front floor console. Refer to Front Floor Console Replacement (Service and Repair) .
4. For programming procedures, refer to Control Module References (Programming and Relearning) .