Object Alarm Module Replacement (L08)

Object Alarm Module Replacement (L08)

Removal Procedure

Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .

Important: When replacing the control unit, before removing the control unit carry out a "Reset" using the Tech 2. For reprogramming procedures, refer to Control Module References (Programming and Relearning) .


1. Disconnect the battery.
2. Open the service flap.




3. Release the rear electronics module (REC).

* Disconnect the 7 wiring harness plugs (1).
* Remove the nut (2).
* Release the retaining lug.





4. Remove the rear object alarm module (REC).
5. Remove the object alarm module.

* Release the control unit (1).
* Disconnect the 2 wiring harness plugs (2).




Installation Procedure

1. Install the object alarm module.
2. Insert the REC.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the REC.

* Fasten the object alarm module .

Tighten the nut (2) to 7 N.m (62 lb in).

* Install the retaining lug.
* Connect the 9 wiring harness plugs.

4. Close the service flap.
5. Connect the battery.
6. For reprogramming procedures, refer to Control Module References (Programming and Relearning) .