Operation CHARM: Car repair manuals for everyone.

Tail Lamp Control Module: Service and Repair



Tail Lamp Circuit Board Replacement

Removal Procedure





1. Remove the combined tail lamp.

* Open the access panel.
* Remove the 2 bolts (2).
* Remove the tail lamp circuit board.
* Disconnect the wiring harness plug (1).





2. Remove the tail lamp holder.
Release the 4 clips (1).
3. Transfer the necessary tail lamp components.



Installation Procedure


Important: Retaining clips must engage audibly.


1. Install the bulb holder.
Install the 4 clips.





Important:
* Before installing the tail lamp, ensure that the tail lamp gasket is seated correctly.

* The gasket (1) with the flat side must not be confused with the gasket (3).



2. Install the gasket (2).

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the tail lamp circuit board.

* Connect wiring harness plug.
* Insert tail lamp circuit board.
* Close the access panel.

Tighten the 2 screws to 5 N.m (44 lb in).