Steering Column Control Module: Service and Repair

Steering Column Control Module Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .

Important: When replacing the control unit, before removing, carry out a Reset using the Tech 2. Refer to Control Module References (Programming and Relearning) .


1. Disconnect the battery.
2. Remove the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement) .




3. Remove the lower steering column paneling.

* Remove the 5 bolts (arrows).
* Remove the ignition lock panel (1).
* Remove the rubber sleeve out of the steering column paneling.





4. Remove the column integration module (CIM).

* Remove the 3 bolts (1).
* Remove the wiring harness holder (arrow).
* Release the wiring harness plug (2) and disconnect.






Important: Disconnect the engaging lug with a suitable tool (1), a hex screwdriver 1.5 mm WAF.


5. Remove the turn signal multifunction switch.

* Remove the retaining lug.
* Remove the actuating lever.






Important:
* The CIM replaces the existing contact unit and contains additional functions.

* The contact unit may not be twisted when it has been removed.

* When removing and installing, ensure that the markings (arrows) are opposite each other as shown in the illustration.



6. Remove the CIM.



Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the CIM.

* Connect and lock the wiring harness plug.
* Install the wiring harness holder.

Tighten the 3 bolts to 3.5 N.m (32 lb in).


2. Install the actuating lever.

* Engage the actuating lever.
* Install the rubber sleeve in the steering column paneling.

3. Install the lower steering column paneling.

* Insert the ignition lock rosette.

Tighten the 5 screws to 1 N.m (9 lb in).

* Install the rubber sleeve in the steering column paneling.

4. Install the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement) .

Important: When replacing the control unit, before removing, carry out a Reset using the Tech 2. Refer to Control Module References (Programming and Relearning) .


5. Connect the battery.
6. For programming procedures, refer to Control Module References (Programming and Relearning) .