Inflatable Restraint Roof Side Rail Module Replacement (Coupe Orginal)
Inflatable Restraint Roof Side Rail Module Replacement (Coupe Orginal)
Removal Procedure
Caution: Refer to SIR Inflator Module Handling and Storage Caution (SIR Inflator Module Handling and Storage Caution) .
Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
Important: The removal and replacement of the windshield is not required.
1. Lower the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (with Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair) .
Important: The roof side rail module cannot be removed without destroying it and must be replaced.
2. Remove the roof side rail module.
* Release and disconnect the wiring harness plug.
* Remove the 2 bolts (1).
* Remove the 6 screws (2).
* Bend up the 6 locks (3).
* Bend up the 6 clamps (4).
Important: Remove the fastening clip with suitable pliers.
3. Remove the 6 fastening clips.
4. Modify the 6 fastening clips.
* Cut off flush with the retaining plate at positions 1, 2 and 3.
* Deburr the edges.
Installation Procedure
1. Use a touch-up pen matching the color of the vehicle to repair any paint damage.
2. Install the 6 fastening clips.
Install the fastening clips.
Notice: Refer to Fastener Notice (Fastener Notice) .
3. Install the new roof side rail module.
Tighten the 8 screws to 1.5 N.m (13 lb in).
4. Connect and latch the wiring harness plug.
Important: The removal and replacement of the windshield is not required.
5. Install the headlining trim panel . Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (with Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair) .