Inflatable Restraint Side Impact Sensor Replacement (5 Door)

Inflatable Restraint Side Impact Sensor Replacement (5 Door)

Removal Procedure

Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .
1. Disconnect the battery.
2. Capacitor discharge waiting time is 1 minute.
3. Position the front seat as far forward as possible.




4. Remove the rear sill inner panelling.

* Remove the 5 clips.
* Remove the inner panelling sill upwards.





5. Remove the side airbag sensor.

* Remove the 2 bolts.
* Disconnect the wiring harness plug.




Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the sensor.

* Connect the wiring harness plug.


Tighten the 2 bolts to 6 N.m (53 lb in).


2. Reposition the driver seat to the previous position.
3. Install the rear sill panelling.
Install the 5 clips.
4. Connect the battery.

Important: After ignition ON, the airbag system readiness indicator illuminates for 4 seconds and then goes out.


5. Preform the readiness inspection.
6. For programming procedures, refer to Control Module References (Programming and Relearning) .