Selector Lever Link Replacement

Selector Lever Link Replacement

Special Tools

KM-527-A Adjuster


Removal Procedure

1. Remove the front floor console. Refer to Front Floor Console Replacement (Service and Repair) .
2. Remove the battery. Refer to Battery Replacement (Battery Replacement) .





Important: Do not remove the bolt.


3. Release the selector lever link.
Loosen the bolt (1) for relay point clamp.




4. Remove the transmission control lever assembly (1).

* Remove the 4 bolts (2).
* Pull out the transmission control lever assembly with selector lever link from the bulkhead.




Installation Procedure





1. Install the transmission control lever assembly (1).

Notice: Refer to Fastener Notice (Fastener Notice) .


Important: Note selector lever link bellows in bulkhead.


2. Feed the transmission control lever assembly with selector lever link through the bulkhead.

Tighten the 4 bolts (2) to 10 N.m (89 lb in).





3. Lock the transmission control lever in adjustment position.

* Push the transmission control lever to the left.
* Lock the transmission control lever and shift lever housing with KM-527-A (1).





4. Lock the selector lever link in the gearbox cover.

* Turn the selector lever link counterclockwise.
Direction of 3rd gear.
* Engage the locking pin (1) in the adjusting bore in the transmission cover (arrow).






Important: Do not change position of selector lever link.


5. Install the selector lever link.

Tighten bolt (1) to 12 N.m (106 lb in) plus 180-225 degrees.





6. Release the transmission control lever lock.
Detach KM-527-A (1)

Important: The locking pin in the adjusting bore hole releases automatically when first shifted in R direction. If necessary, release the locking pin by hand.


7. Release the locking pin in the transmission cover.
8. Inspect the ease of gear shifting.

* With vehicle standing
* With engine running
* With clutch disengaged

9. Install the battery. Refer to Battery Replacement (Battery Replacement) .
10. For programming procedures, refer to Control Module References (Programming and Relearning) .
11. Install the front floor console. Refer to Front Floor Console Replacement (Service and Repair) .