Engine Electrical
DTC P0562
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0562
- System Voltage Low
Diagnostic Fault Information
Circuit/System Description
The engine control module (ECM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components, and incorrect data may occur when the voltage is out of range.
Conditions for Running the DTC
* The vehicle speed is greater than 8 km/h (5 mph).
* The system voltage is between 9.5-18 volts.
Conditions for Setting the DTC
The ECM detects a system voltage less than 10 volts for 5 seconds.
Action Taken When the DTC Sets
* The ECM will command the charge indicator to be illuminated on the instrument panel cluster (IPC).
* The driver information center (DIC) will display the CHECK CHARGE SYSTEM message.
Conditions for Clearing the DTC
* The ECM will command the message OFF after one trip in which the diagnostic test has been run and passed.
* The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
Reference Information
Schematic Reference
* Starting and Charging Schematics ([1][2]Electrical Diagrams)
* Control Module References (Programming and Relearning) for ECM schematics
Connector End View Reference
Component Connector End Views (Connector Views)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for Scan Tool Information
Diagnostic Aids
A low voltage DTC in multiple modules indicates a concern in the charging system.
Circuit/System Verification
1. Ignition On. Measure and record the voltage at the battery terminals. Verify that the battery voltage is 12-17 volts. Repeat with the engine running.
• If the battery voltage is not within the specified range, go to Charging System Test (Charging System Test).
2. Observe the Ignition 1 Signal parameter in the ECM scan tool data list. Verify that the scan tool displays a value that is within 2 volts of the battery voltage recorded in step 1.
• If the scan tool parameter is not within the specified range, go to Circuit/System Testing.
3. Go to Diagnostic Aids.
Circuit/System Testing
1. Ignition OFF. Disconnect the harness connector of the ECM. Verify that there is less than 1.0 ohm between the ground circuits and the negative battery terminal.
• If greater than the specified value, test the ground circuit for an open/high resistance.
2. Test for 11-14 volts between the battery positive voltage and the ground circuits of the ECM.
• If not within the specified range, test the battery positive voltage circuits for a short to ground or an open/high resistance.
3. If all circuits test normal, test or replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for ECM replacement, setup, and programming.