Pedal Positioning Sensor: Service and Repair

Brake and Accelerator Pedal Adjustment Position Sensor Replacement

Removal Procedure

1. Remove the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).
2. Remove the intermediate steering shaft bolt and position the intermediate steering shaft away from the steering column in order to gain access to the brake pedal adjustment position sensor. Refer to Intermediate Steering Shaft Replacement (Intermediate Steering Shaft Replacement).
3. Disconnect the electrical connector from the brake and accelerator pedal adjustment position sensor.




4. Remove the brake and accelerator pedal adjustment position sensor bolt (1) and sensor (2).



Installation Procedure






Important: Ensure that the brake and accelerator pedal adjustment position sensor is installed correctly to the bracket. The brake and accelerator pedal adjustment position sensor has a sensing arm that must be installed over the brake pedal actuation arm to insure it is sensing brake pedal position.


1. Install the brake and accelerator pedal adjustment position sensor (2) to the brake pedal bracket. Ensure the brake pedal position sensor tab locks into the brake pedal bracket and the sensors arm is correctly installed.

Notice: Refer to Fastener Notice (Fastener Notice).

2. Install the brake pedal adjustment position sensor bolt (1).

Tighten the bolt to 2 N.m (18 lb in).

3. Connect the electrical connector to the brake and accelerator pedal adjustment position sensor.
4. Install the intermediate steering shaft to the steering column. Refer to Intermediate Steering Shaft Replacement (Intermediate Steering Shaft Replacement).
5. Install the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).