60. Crankshaft Balancer Installation

Crankshaft Balancer Installation


Tools Required
* EN-48585 Crankshaft Balancer Guide
* J 38122-A Crankshaft Balancer Holder
* J 45059 Angle Meter






1. Install a new friction washer.

Notice: Ensure both components are aligned correctly or serious engine damage will occur.

2. Install the EN-48585 into the end of the crankshaft.
3. Install the balancer onto the EN-48585. Use care to properly align the keyway and flats on the balancer with the oil pump drive.




4. Install the J 38122-A.

Notice: Refer to Fastener Notice.


Important: Always install a new crankshaft balancer retaining bolt and washer.


5. Install a new retaining bolt and washer. Use the J 38122-A and a breaker bar to prevent the crankshaft from rotating when tightening the bolt.

Tighten the bolt to 100 N.m (74 lb ft) plus 125 degrees using the J 45059.