Transmission Rear Mount Replacement (First Design)

Transmission Rear Mount Replacement (First Design)

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals).
2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Using a suitable jack stand, support the rear of the powertrain.




4. Remove the transmission mount to bracket through bolt.




5. Remove the transmission mount to transmission bolts.
6. Disconnect the HO2 sensor Harness from the transmission mount bracket.




7. Remove the transmission mount to frame nuts.
8. Remove the transmission mount and bracket.



Installation Procedure

1. Install the transmission mount and bracket.





Notice: Refer to Fastener Notice (Fastener Notice).

2. Install the transmission bracket to frame nuts.

Tighten the nuts to 50 N.m (37 lb ft).

3. Connect the HO2 sensor harness to the transmission mount bracket.




4. Install the transmission mount to transmission bolts.

Tighten the bolts to 90 N.m (66 lb ft).





5. Install the transmission mount to bracket through bolt.

Tighten the bolt to 90 N.m (66 lb ft).

6. Remove the jack stand.
7. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
8. Lower the vehicle.