6T70/6T75 - Automatic Transmission

DTC P0601, P0602, P0603, P0604, or P062F

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptors
DTC P0601
- Transmission Control Module (TCM) Read Only Memory (ROM)

DTC P0602
- Transmission Control Module (TCM) Not Programmed

DTC P0603
- Transmission Control Module (TCM) Long Term Memory Reset

DTC P0604
- Transmission Control Module (TCM) Random Access Memory (RAM)

DTC P062F
- Transmission Control Module (TCM) Long Term Memory Performance




Circuit/System Description

This is an internal fault detection of the control solenoid (w/body and TCM) valve assembly. This fault is handled inside the control solenoid (w/body and TCM) valve assembly and no external circuits are involved.


Conditions for Running the DTC

The ignition is ON.


Conditions for Setting the DTC

The control solenoid (w/body and TCM) valve assembly has detected an internal malfunction.


Action Taken When the DTC Sets

* DTCs P0601, P0602, P0603, P0604, and P062F are Type A DTCs.
* The TCM shifts to a default gear, shuts down, and turns OFF.



Conditions for Clearing the DTC

DTCs P0601, P0602, P0603, P0604, and P062F are Type A DTCs.


Reference Information
Description and Operation

Electronic Component Description (Electronic Component Description) for control solenoid (w/body and TCM) valve assembly
DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information


Circuit/System Verification

1. Engine running for at least 1 minute.
2. Ignition OFF for 30 seconds
3. Ignition ON, verify that DTC P0602 is not set.

• If the DTC is set, program the transmission control module (TCM). If the DTC resets, replace the control solenoid (w/body and TCM) valve assembly.

4. Observe the DTC information with a scan tool. DTCs P0601, P0603, P0604, and P062F should not set.

• If a DTC sets, replace the control solenoid (w/body and TCM) valve assembly.

5. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Important: Perform the Service Fast Learn Adapts (Programming and Relearning) any time a transmission related component is serviced.



Control Module References (Programming and Relearning) for control solenoid (w/body and TCM) valve assembly replacement, setup, and programming.