Windshield Wiper System Module Replacement

Windshield Wiper System Module Replacement

Removal Procedure

Important: The new wiper drive system module does not include the wiper motor nor the motor support bracket. You must install the old components to the new wiper system module.







1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement (Service and Repair).
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Service and Repair).
3. Remove the bolts attaching the wiper module to the plenum.
4. Carefully lift the wiper module out of the plenum.
5. Disconnect the electrical connector from the wiper motor.
6. Disconnect the clip retaining the electrical harness to the wiper module.
7. Remove the wiper module assembly from the vehicle.




8. Remove the wiper motor. Refer to Windshield Wiper Motor Replacement (Windshield Wiper Motor Replacement).



Installation Procedure





1. Install the wiper motor. Refer to Windshield Wiper Motor Replacement (Windshield Wiper Motor Replacement).
2. Connect the electrical connector to the wiper motor.
3. Connect the clip retaining the electrical harness to the wiper module.




4. Position the wiper module assembly into the plenum.

Notice: Refer to Fastener Notice (Fastener Notice).

5. Install the fasteners attaching the wiper module assembly to the plenum.

Tighten the fasteners to 10 N.m (89 lb in).

6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Service and Repair).
7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement (Service and Repair).
8. Inspect the washers for proper operation.