Power Steering

DTC C0569

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC C0569
- System Configuration Error




Circuit/System Description

After replacing the power steering control module (PSCM) it must be setup with the correct steering tuning.


Conditions for Running the DTC

The ignition is ON.


Conditions for Setting the DTC

The PSCM has not undergone the steering tuning selection procedure.


Action Taken When the DTC Sets

* DTC C0569 46 is stored in memory.
* The driver information center (DIC) displays the POWER STEERING warning message.
* The PSCM defaults to steering tuning 1.



Conditions for Clearing the DTC

* A current DTC will clear after the PSCM has been setup with the correct steering tuning.
* A history DTC will clear after 100 consecutive malfunction-free ignition cycles from when the PSCM has been setup.



Diagnostic Aids

A newly replaced PSCM will set DTC C0569 46 on its initial ignition ON cycle.


Reference Information
Schematic Reference

Power Steering Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Power Steering System Description and Operation (HPS) (Power Steering System Description and Operation (HPS))Power Steering System Description and Operation (EPS) (Power Steering System Description and Operation (EPS))
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information


Circuit/System Verification

Verify that C0569 is not set as current.

If the DTC is set, perform the PSCM setup procedure. If the DTC resets, replace the PSCM.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning) for PSCM replacement, setup, and programming