Operation CHARM: Car repair manuals for everyone.

P1831



DTC P1831 or P1832

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptors
DTC P1831
- Pressure Control (PC)/Shift Lock Solenoid Control Circuit Low Voltage

DTC P1832
- Pressure Control (PC)/Shift Lock Solenoid Control Circuit High Voltage




Circuit/System Description

The transmission control module (TCM) high side driver 1 is located inside of the control solenoid (w/body and TCM) valve assembly and is not serviced separately. The high side driver 1 provides the voltage for the TCM pressure control solenoids and shift solenoids. This fault is handled inside the TCM and no external circuits are involved.


Conditions for Running the DTC


P1831
* The engine speed is greater than 500 RPM for 5 seconds.
* Ignition voltage is between 8.6 volts and 19.0 volts.
* High side driver 1 is enabled.
* DTC P1831 has not failed this ignition cycle.


P1832

DTC P1832 has not failed this ignition cycle.


Conditions for Setting the DTC

P1831

The TCM detects an internal open or short to ground in the high side driver 1 for 0.3 second or greater of a 0.5 second sample.

P1832

The TCM detects an internal short to voltage on the high side driver 1 circuit for 0.3 second or greater of a 0.5 second sample.


Action Taken When the DTC Sets


P1831
* DTC P1831 is a Type A DTC.
* The TCM turns OFF all high side drivers.
* The TCM turns OFF all solenoids.
* The TCM commands maximum line pressure.
* the TCM freezes transmission adaptive functions.
* The TCM commands the TCC OFF.
* The TCM allows the vehicle to operate in transmission protection mode.


P1832

DTC P1832 is a Type C DTC.


Conditions for Clearing the DTC

* DTC P1831 is a Type A DTC.
* DTC P1832 is a Type C DTC.



Reference Information
Description and Operation

Transmission General Description (Transmission General Description)
DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information


Circuit/System Verification

1. Ignition ON, clear the DTCs with a scan tool.
2. Operate the vehicle within the Conditions for Running and Setting the DTC. The DTCs should not set.

If a DTC sets, replace the control solenoid (w/body and TCM) valve assembly.

3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Important: Perform the Service Fast Learn Adapts (Programming and Relearning) following all transmission related repairs


Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (Control Solenoid Valve and Transmission Control Module Assembly Inspection)



Control Module References (Programming and Relearning) for control solenoid (w/body and TCM) valve assembly replacement, setup, and programming