Indicator/Warning Message Description and Operation

Indicator/Warning Message Description and Operation
















CHANGE OIL SOON

The driver information center (DIC) displays the CHANGE ENGINE OIL message when the engine control module (ECM) determines that the engine oil life is 0 percent. The ECM sends a serial data message to the body control module (BCM) to request the DIC to display the CHANGE ENGINE OIL message. After the oil is changed, reset the engine oil monitor. Refer to GM Oil Life System Resetting (Service and Repair) .


ENGINE OIL PRESSURE

The instrument panel cluster (IPC) illuminates the engine oil pressure (EOP) indicator when the engine control module (ECM) detects the EOP is low from the EOP sensor/switch. The ECM sends a serial data message to the body control module (BCM) indicating a low EOP condition. The IPC receives a serial data message from the BCM requesting the EOP indicator.


ICE POSSIBLE

The driver information center (DIC) displays the ICE POSSIBLE message when the outside air temperature drops below 2°C (36°F). When the temperature rises above 5.5°C (42°F), the ICE POSSIBLE message turns OFF. The IPC receives a serial data message indicating the outside air temperature from the body control module (BCM).


LOW FUEL

The driver information center (DIC) displays the low fuel message as determined by the engine control module (ECM). The ECM monitors the fuel level sensor signal and will request the LOW FUEL message from the body control module (BCM) when the fuel level is less than 14 percent. The IPC receives a serial data message from the BCM requesting display of the LOW FUEL message.


LOW FUEL

The instrument panel cluster (IPC) displays the low fuel indicator as determined by the engine control module (ECM). The ECM monitors the fuel level sensor signal and will request the LOW FUEL indicator from the body control module (BCM) when the fuel level is less than 14 percent. The IPC receives a serial data message from the BCM requesting display of the LOW FUEL message.


LOW OIL LEVEL

The driver information center (DIC) displays the LOW OIL LEVEL message when the engine control module (ECM) detects a low oil level condition from the engine oil level sensor/switch. The ECM sends a serial data message to the body control module (BCM) requesting a low oil level message. The DIC receives a serial data message from the BCM requesting the engine oil level message.


SERVICE VEHICLE SOON

The instrument panel cluster (IPC) displays the Service Vehicle Soon indicator when the following conditions exists:

* The body control module (BCM) detects certain malfunctions that are not emissions related. The IPC receives a serial data message from the BCM requesting the display of the Service Vehicle Soon indicator.
* The IPC detects a loss of serial data communications from the BCM.