62. Crankshaft Balancer Installation

Crankshaft Balancer Installation


Tools Required
* EN-48585 Crankshaft Balancer Guide
* J 45059 Angle Meter
* EN-48585 Crankshaft Balancer Guide







Notice: Ensure both components are aligned correctly or serious engine damage will occur.

1. Install the EN-48585 into the end of the crankshaft.
2. Install the balancer onto the EN-48585 . Use care to properly align the keyway and flats on the balancer with the oil pump drive.

Notice: Refer to Fastener Notice .


Important: Always install a NEW crankshaft balancer retaining bolt and washer.


3. Install a NEW retaining bolt and washer. Prevent the crankshaft from rotating when tightening the bolt.

Tighten the bolt to 100 N.m (74 lb ft) plus 125 degrees using the J 45059 .