P0610

DTC P0610

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provide an overview of each diagnostic category.

DTC Descriptor
DTC P0610
- Control Module Vehicle Options Incorrect

Circuit/System Description

This diagnostic verifies that the engine control module (ECM) is programmed for the correct vehicle options.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The ECM detects that programming for vehicle options is incorrect.

Action Taken When the DTC Sets

DTC P0610 is a Type A DTC.

Conditions for Clearing the MIL/DTC

DTC P0610 is a Type A DTC.

Reference Information
Schematic Reference

Component Connector End Views (Connector Views)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. View the stored DTCs with a scan tool. DTC P0610 should not be current.
2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

Circuit/System Testing

1. Program the ECM. Refer to Control Module References (Programming and Relearning).
2. Clear DTCs with a scan tool.
3. Ignition OFF, allow the ECM to completely power down.
4. Operate the vehicle within the Conditions for Running and Setting DTC P0610.
5. Verify with a scan tool that DTC P0610 has run and passed.

• If DTC P0610 does not pass, replace the ECM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for ECM replacement, setup, and programming