Alarm Module: Service and Repair

Theft Deterrent Module Replacement

Removal Procedure
Warning: Refer to Battery Disconnect Warning (Service Precautions).


Note: When replacing the control unit, before removing the control unit, carry out a "Reset" using Tech 2. For reprogramming procedures, refer to Control Module References (Programming and Relearning).

1. Disconnect the battery.
2. Remove the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement).




3. Remove the lower steering column panel.

* Remove the 5 bolts (arrows).
* Remove the ignition lock panel (1).




4. Remove the column integration module (CIM).

* Remove the 3 bolts (1).
* Disconnect the wiring harness holder (arrow).
* Release the wiring harness plug (2) and disconnect.




5. Remove the theft deterrent module.

* Release the 2 clips (1, 2).
* Remove the module.

Installation Procedure

1. Install the theft deterrent module.
Install the 2 clips.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the CIM.

* Connect and lock the wiring harness plug.
* Connect the wiring harness holder.

Tighten the 3 bolts to 2.5 Nm (22 lb in).

3. Install the lower steering column panel.
Install the ignition lock panel.

Tighten the 5 screws to 2.5 Nm (22 lb in).

4. Install the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement).
5. For reprogramming procedures, refer to Control Module References (Programming and Relearning).