Power Mirrors Inoperative
Power Mirrors Inoperative
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The outside rearview mirror switch controls the outside rearview mirrors based on the position of the mirror selector switch and which movement position is selected. The outside rearview mirror switch has four positions: up, down, left, and right. B+ is applied to the switch and when a movement position switch is selected, B+ is sent to the mirror via a motor control circuit. The opposite motor control circuit acts as a ground circuit for the bi-directional mirror motor.
Reference Information
Schematic Reference
Outside Rearview Mirror Schematics (Outside Rearview Mirror Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Outside Mirror Description and Operation (Outside Mirror Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool References
Control Module References (Programming and Relearning) for scan tool information.
Circuit/System Verification
1. Ignition ON, with the mirror selector switch in the DRIVER position, command the mirrors UP, DOWN, LEFT, and RIGHT using the mirror directional switch. The driver mirror should move in the commanded direction.
2. Ignition ON, with the mirror selector switch in the PASSENGER position, command the mirrors UP, DOWN, LEFT, and RIGHT using the mirror directional switch. The passenger mirror should move in the commanded direction.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate outside rearview mirror.
2. Connect a test lamp between the control circuit terminal 1 and the control circuit terminal 3.
3. Operate the vertical switch UP and DOWN. The test lamp should turn ON when commanding the UP and DOWN states.
• If the test lamp remains OFF during either of the commands, test for a short to voltage, short to ground, or an open/high resistance on the control circuits. If the circuits test normal, replace the front side door window switch.
4. Connect a test lamp between the control circuit terminal 2 and the control circuit terminal 3.
5. Operate the vertical switch LEFT and RIGHT. The test lamp should turn ON when commanding the LEFT and RIGHT states.
• If the test lamp remains OFF during either of the commands, test for a short to voltage, short to ground, or an open/high resistance on the control circuits. If the circuits test normal, replace the front side door window switch.
6. If all circuits test normal, test or replace the outside rearview mirror.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Front Side Door Window Switch Replacement (Front Side Door Window Switch Replacement)
* Power Mirror Replacement (Power Mirror Replacement)