Sunroof Module Assembly Replacement
Sunroof Module Assembly Replacement
Removal Procedure
1. Lower the molded headlining. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair).
2. Remove the front water drain hose actuation unit.
Remove the 2 hoses.
3. Remove the rear water drain hose actuation unit.
Remove the 2 hoses.
4. Disconnect the front wiring harness actuation unit.
Disconnect the 2 wiring harness plugs.
5. Release the sunroof module assembly.
Remove the 20 screws.
6. Remove the sunroof module assembly.
Installation Procedure
Caution: Refer to Fastener Caution (Fastener Caution).
1. Insert the sunroof module assembly.
Fasten with 3 screws.
2. Install the sunroof module assembly.
Tighten the 20 screws to 5 Nm (44 lb in).
3. Connect the front wiring harness actuation unit.
Connect the 2 wiring harness plugs.
4. Install the rear water drain hose actuation unit.
Connect the 2 hoses.
5. Install the front water drain hose actuation unit.
Connect the 2 hoses.
6. Install the molded headlining. Refer to Headlining Trim Panel Replacement (Sedan) (Service and Repair)Headlining Trim Panel Replacement (With Sunroof) (Service and Repair)Headlining Trim Panel Replacement (Coupe) (Service and Repair).